Basic parameters — zones, partitions, users and outputs — are set right on the panel, section number first, then the data. Every accepted entry is confirmed with a beep, and the zone LEDs show the number being typed.
You will need
Master code (default 123456), panel disarmed
Important
The master code is for programming only: arming and disarming use personal user codes. Change the factory code after commissioning.
- 1
Enter the mode
On a disarmed panel press “ACCESS” and “TEST” together and enter the master code — the “ACCESS” indicator lights up.
- 2
Dial a section number
1–24 — zones, 101–124 — partitions, 201–216 — users, 301–304 — monitoring outputs, 900 — loop calibration.
- 3
Fill in the fields
Every value is confirmed with “ACCESS”; the zone LEDs show the number being typed, the colour changes per field.
- 4
Save the record
The final “ACCESS” stores the record with a double beep, “RESET” returns to section input.
- 5
Leave the mode
Press “RESET” at section input — the panel returns to standby.
The result
Zones, partitions and users are written to the panel’s non-volatile memory; names and communication channels are easier to finish later in the configurator.